Vehicle Standard (Australian Design Rule Definitions and Vehicle Categories) 2005.ĥ.1. Definitions in Section 3 of Appendix A of this standard or Section 3 of the alternative standard at clause 7.1 and where there is no conflictĤ.3. For vehicle categories, definitions and meanings used in this standard, refer to:Ĥ.2. Over 3.5 tonnes and up to 4.5 tonnes ‘GVM’Ĥ.1. Up to 3.5 tonnes ‘GVM’ and more than 12 seats Up to 3.5 tonnes ‘ GVM’ and up to 12 seats This standard is optional for NB2 category vehicles. For information purposes, a copy of the relevant definitions referenced at Appendix A, clause 1.3. This standard does not apply to off-road vehicles as specified in Appendix A, clause 1.3, or vehicles such that their use is incompatible with the provisions of front underrun protection.ģ.4.1. For the purposes of clause 3.1 a "new model" is a vehicle model first produced with a 'Date of manufacture' on or after the agreed date in clause 3.1.ģ.4. 1 January 2011 on all new model vehicles.ģ.3. This standard applies to the design and construction of NC category vehicles as set out in clauses 3.1, 3.2, 3.3 and the table below.ģ.1. This standard prescribes requirements to minimise the likelihood of vehicles underrunning in frontal impacts. This standard commences on the day after it is registered. This standard may also be cited as Australian Design Rule 84/00 - Front Underrun Impact Protection.ġ.2.1. This standard is the Vehicle Standard (Australian Design Rule 84/00 – Front Underrun Impact Protection) 2007.ġ.1.2.
0 Comments
Leave a Reply. |